Not Found

Your multilingual tech support gateway

You can search by error code or description.

 Ex:
    1. error code EID / F1
    2. fix room temperature not cooling / washer not draining

haier | dishwasher – Leak Detected – Water in Base Tray
Error Codes (AE): Troubleshooting, Fixes & Prevention Tips explained below.

What Does Leak Detected Mean❓

The Leak Detected error means that water has accumulated in the dishwasher’s base tray. Most modern dishwashers have a leak detection system with a float switch or sensor in the bottom tray to prevent flooding. When water is present in this area, the machine stops operating to avoid further leakage and potential damage. This condition may be caused by loose hose connections, faulty seals, or internal cracks in components.

dishwasher - Common Causes of Leak Detected

  • Damaged or worn door gasket causing water to escape.
  • Loose or disconnected hoses underneath the dishwasher.
  • Cracked tub, spray arm, or pump housing.
  • Overfilling due to faulty inlet valve or float switch.
  • Debris buildup causing drainage issues or backflow.

dishwasher - Steps to Fix Leak Detected❓

  • Turn Off and Unplug the Dishwasher

    1. Immediately switch off the power and disconnect the unit from the electrical supply.
    2. This prevents further risk and allows inspection.

  • Remove Excess Water from Base Tray

    1. Tilt or open the dishwasher to carefully dry out the base tray.
    2. Use a sponge or towel to remove visible water.

  • Check for Leaks or Loose Connections

    1. Inspect hoses, seals, and the sump area for signs of dripping or cracks.
    2. Tighten loose clamps or replace damaged parts.

  • Test After Resetting

    1. Reconnect power and run a short cycle.
    2. Monitor for any new leaks during operation.

dishwasher - Helpful Tips to Prevent Leaks

  • Inspect and clean door seals regularly to ensure a tight fit.
  • Avoid overloading the dishwasher to prevent splash leaks.
  • Use proper detergent types and quantities to reduce excess suds.
  • Check hoses and connections for signs of wear or looseness.
  • Schedule routine maintenance checks especially in high-usage households.

FAQs About Leak Detected❓

Question: Can the dishwasher run if water is in the base tray
Answer: No, the machine will usually stop to prevent damage once a leak is detected.
Question: Is a leak always caused by a broken part
Answer: Not always, it can also result from improper loading or detergent overflow.
Question: Can I dry out the base and restart the cycle
Answer: Yes, after drying and checking for leaks, restarting may clear the error temporarily.
Question: Do I need to replace the leak sensor
Answer: Only if it becomes water-damaged or fails to reset even after removing the leak.

When to Contact a Technician

If you experience any of the following issues even after completing the recommended troubleshooting steps, please contact an authorized service technician or our support team for further assistance.

  • The same error appears repeatedly after restarting or resetting the unit.
  • Multiple error codes appear simultaneously.
  • The device makes unusual noises, vibrations, or emits a burning smell.
  • The product fails to start, operate, or complete its function despite troubleshooting.
  • There are signs of electrical issues, physical damage, or leakage.
  • An unknown or unlisted error code appears on the display.

Query / Feedback Form

Have a question or concern? Submit your query and we`ll get back to you!