Not Found

Your multilingual tech support gateway

You can search by error code or description.

Water Inlet Failure – Dishwasher Not Filling (DW-IE-1E-4E)

Dishwasher is unable to fill with water. Causes: closed water tap, low water pressure, blocked inlet filter, or faulty inlet valve.

Drainage Failure – Dishwasher Not Draining (DW-OE-5E-E24)

Water remains inside after wash. Likely causes: clogged drain filter, blocked or kinked drain hose, or faulty drain pump.

Leak Detected – Water in Base Tray (DW-AE-E1-LE)

Water has leaked into the base of the dishwasher. Triggered by the leak sensor. Check door seals, hoses, and float switch.

Overflow Error – Too Much Water Inside (DW-FE)

Dishwasher is overfilled. May be caused by faulty water inlet valve, float switch, or level sensor.

Heating System Failure – Water Not Heating (DW-HE-tE-E09)

Water is not reaching desired temperature. Could be due to a broken heating element, faulty thermistor, or wiring issue.

Circulation Pump/Motor Error (DW-LE-CE-E20)

The motor responsible for spraying water is jammed, overheated, or electrically faulty.

Oversudsing Error – Too Much Detergent (DW-bE-SUD)

Excess foam detected in the tub. Caused by using regular dish soap or overdosing detergent. Run rinse cycle and avoid repeat use.

Control Panel Locked – Child Lock Active (DW-CL-LOC)

Buttons are unresponsive because the child lock is enabled. Disable by holding down specific button(s) for 3–5 seconds.

Power Interruption – Cycle Halted (DW-PF)

Power was lost during the cycle. The dishwasher may resume or need to be restarted manually.

Spray Arm/Diverter Error – Water Not Circulating Properly (DW-nE)

The diverter motor that switches water flow between spray arms is malfunctioning. Check for jams or replace motor.

Tub Clean Reminder – Maintenance Alert (DW-tCL-0C)

Not a fault. Indicates it’s time to run a tub cleaning cycle to maintain hygiene and performance.

20

11